16
3DISON AEP U
ser M
anual
Notice
※ Choose Hot-End separately for each filaments. (Left Hot-End : under 270 ℃ / Right Hot-End : over 300 ℃)
(Left Hot-End : PLA, ABS, PC / Right Hot-End : ULTEM
TM
resin grade 9085)
※ Default setting for materials. (Nozzle/Speed): PLA215(Speed 80), ABS 280(Speed 60), PC 270(Speed 50)
ULTEM
TM
resin grade 9085 365 ℃(Speed 35)
※ The Hot-End has top Heat-Bed. (Turn it on when you print ULTEM
TM
resin grade 9085 only)
※ You can change temperature setting while printing is on going, using Heat-Bed temperature controller.
※ This 3D printer is equipped with Door-Sensor.
(If you set “Utilities > Door Sensor ‘On’, the printer will be paused automatically when the door open while printing)
※ Recommended temperatures setting for following materials. (PLA 70℃, ABS 160℃, PC 150℃, ULTEM
TM
resin grade 9085 220℃)
※ Before removing a printed object, cool down the Heat-Bed more than 10 minutes.
※ Comply with the procedure of preheat for the quality of printing.
(The time of stabilizing Heat-Bed & rising the temperature of inner air)
※ Please put on gloves always because of the high temperature of Hot-End & Heat-Bed.
※ Please readjust temperature before printing other materials. Otherwise temperature setting would be remained same as before.
※ Always turn off a top Heat-Bed when printing materials other than ULTEM
TM
resin grade 9085.
※ Seal unused filaments and store in low humidity place.
※ If printed object made of ULTEM
TM
resin grade 9085 is too complicated or small, it is recommended to control temperature and speed.
(Temperature is ranged from 360 to 375. Temperature and speed are proportional so adjust temperature within a range from 5% to 10%)
※ You can download Create K program on ROKIT
’
s website for free. Additional user manual is also downloadable on the
website.
※ ULTEM
TM
is a registered trademark of SABIC or its affiliates or subsidiaries.
