12
3DISON AEP U
ser M
anual
Display Menu Introduction
There are 3 configuration items on the display menu; Print from SD, Preheat and Utilities.
1. Print from SD:
To load a file from SD card.
2. Preheat:
To preheat the Hot-End(Nozzle) and platform.
-
Right Tool: By setting On/Off, you can start preheating of the right extruder.
-
Left Tool: By setting On/Off, you can start preheating of the left extruder.
3. Utilities:
It will lead to 17 different options for hardware. You may not want to change the settings without specific explanation
because they are only for developers or aftersales service.
-
Filament Loading: To put the filament into the extruder or pull it out of the extruder.
-
Auto Level Setting: To manually level the printing bed before start Auto-Leveling.
-
Auto Level On/Off: Choose On/Off setting of Auto-Leveling
Choose On/Off setting when you create G-Code(From Creator K) depending on Auto-Leveling use.
(When you choose not to use Auto-Leveling when making file, you should turn off Auto-Leveling function on the machine as well)
-
Standard Leveling: Use to level the Heat-Bed manually.
-
Monitor Mode: It shows current temperature of the extruder and printing status.
-
Preheat Settings: To set up temperature and the extruder.
-
Heat Bed On/Off: Use to turn On/Off the Heat-Bed to adjust setting.
-
Top Heat Bed On/Off
:
Use to turn On/Off top Heat-Bed when printing
ULTEM
TM
material.
-
Top Heat Bed Power: Control power of top Heat-Bed.
How to use 3DISON AEP
※ ULTEM
TM
is a registered trademark of SABIC or its affiliates or subsidiaries.
