www.rojaflex.com
9
1
2
3
4
Mounting the motor
1. Lay the connecting cable in an empty pipe up to the junction box,
observing the local building and electrical regulations.
2. Lower the shutter completely and loosen the shaft connection.
3. Disassemble the roller shutter shaft.
4. Mount the motor bearing included in the scope of delivery on the
side on which you want to mount the motor.
The motor can be installed on the left or right.
5. Push the barrel ring adapter over the barrel ring on the motor head
as far as it will go ( 1 ).
Make sure that the groove in the adapter is in the correct position.
6. Push the motor into the roller shutter shaft until it is completely
inserted with the race in the shaft ( 2 ).
ATTENTION!
Never use a hammer when doing this!
Adapters and drivers may not slide in very smoothly,
nevertheless do not hit the motor!
ATTENTION!
The roller capsule or telescopic shaft must be secured
against displacement!
7. Check whether the shaft with the installed motor can be mounted
appropriately in the roller shutter box or whether you may have to
shorten the shaft.
On the counter bearing side (opposite the motor side) is the roller
capsule or telescopic shaft. These can be pushed a few centimeters
into the roller shutter shaft or pulled out of the shaft.
8. Insert the motor inserted into the shaft into the motor bearing and
the shaft with the journal of the roller capsule into the counter
bearing ( 3 ).
Secure the square spigot of the motor head with the locking pin
included with the bearing.
9. Fasten the roller capsule with two opposite screws ( 4 ).
NOTE!
The roller capsule (counter bearing side) is usually
secured with 2 opposite screws.
Mounting
