Rointe EASY Touch, Easy Setup Manual

Page: 6 / 32

EASY Touch
6
EN
PROGRAMMING THE THERMOSTAT
To program your thermostat all you need to do is move the Program Slide control on the right hand side of your thermostat from
top to bottom. The table below will explain what you can do at each step.
Set Time /Day Turn the Rotary Control to change the current clock time. Once the clock time has been set, press the Main Button, you will
now be able to set the day of the week. Turn the Rotary Control to select the correct day.
Set Timing
1
2
3
4
When in any of these positions you can set the start time for “morning” (1), ”day” (2), ”evening” (3) and “night “ (4) periods.
The “morning” and “evening” periods will follow the comfort temperature, “day” and “night” periods will follow the setback
temperature. Using the Rotary Control, select the start time and press the Main Button to move to the next day.
If you hold the Main Button for 3 seconds it will copy the start time to the next day.
Tip - If you want to set the thermostat so that it is keeping the comfort temperature all day and only setback at night, then
just set the “day” start time equal to the “evening” start time.
Set
Temperatures Here you can set the temperature which will be used for the comfort and setback temperatures.
Done Move the Program Slide control to the lowest position in order to start your thermostat. Heating will not occur if the
Program Slide control is not in this position.
ERROR MESSAGES
The thermostat is not
controlling the temperature Ensure that the Program Slide is in the run position (lowest point) and that the Mode Slide control (bottom) is in the
manual or program positions.
Floor sensor error If you see the floor sensor error icon or “ - - “ on the screen it means that your thermostat has been unable to
detect the temperature of the floor.
Overheat If you see the overheat icon this means that your floor has become too hot and the heating has been suspended.
Low battery The low battery icon will display when the battery needs to be replaced. The thermostat must be connected to the
mains electricity supply in order to work, it is not designed to be used with an intermittent power supply. If the battery is
not installed then your thermostat will not be able to maintain the clock time if power is lost.