11
ROHO AGILITY Back System Fixed Hardware Operation Manual
Seat Depth and Angle Adjustment, Continued
To Adjust the Angle
1)
If not yet loosened, use the Allen wrench
to loosen the depth/angle adjustment
bolts
approximately
two (2) full
rotations.
2)
Pivot the back shell.
IMPORTANT! Compare the markers on
the front of the fixed hardware to make sure
both sides are rotated the same.
3)
While you hold the back shell in position,
use the Allen wrench to tighten the right
and left depth/angle adjustment bolts,
turning until snug + one-quarter turn.
Note: If a torque wrench is available,
tighten the bolts to 60 ± 4 inch-pounds
(7 ± 0.5 Newton-meters)
IMPORTANT! After installation and adjustment is complete, tighten hardware securely before transferring into the wheelchair.
Refer to the appropriate sections in this manual for recommended torque specifications. If the individual is seated in the
wheelchair, and depth and angle re-adjustments are needed, review
W
arningS
at the beginning of this section and re-adjust as
necessary. Re-tighten all hardware securely.
Flip the Back Shell
1)
Remove the AGILITY from the wheelchair. See
agility r
eMoval
.
2)
Remove the back shell hardware
:
-
U
se
the box end wrench to remove the width/height
adjustment nuts.
-
Remove the triangle brackets from the back shell.
3)
Rotate the back shell.
4)
Install and adjust the AGILITY. See all adjustment and
installation instructions provided with the product.
Triangle
Bracket
2x