9
ROHO AGILITY Back System Fixed Hardware Operation Manual
Height Adjustment, Continued
1)
On both sides: Use the box end wrench
to loosen the width/height adjustment
nuts:
DO NOT remove the width/height
adjustment nuts.
From a tight position, loosen the nuts
less than the equivalent of two (2)
full rotations. The nuts should be just
loose enough to allow the width/height
adjustment plate to slide up and down.
2)
Slide the back shell up or down in the
vertical slots to the desired height:
3)
While you hold the back shell in
position, use the box end wrench to
tighten the width/height nuts on the
width/height adjustments bolts until
snug + one-quarter turn. Note: If a
torque wrench is available, tighten the
bolts to 42 ± 2 inch-pounds (4.75 ±
0.25 Newton-meters).
IMPORTANT! Make sure that the
back shell hardware is the same height on
both sides:
To make sure that the left (L)
back shell hardware and the right (R)
back shell hardware are at the same
height, count the squares that you can
see when you look through the left and
right vertical slots in the back shell.
(The squares are part of the sliding
height adjustment bar
.
See
p
artS
d
etail
.)
Warning: Once adjustment is
complete, make sure all hardware is
securely tightened
.
Refer to the
recommended torque specifications.