Espresso maker R-990
EN
6
2.
Set steel mesh into metal funnel (no coffee in steel mesh).
3.
Place an jug on removable shelf. Make sure the steam control knob is on the
OFF position.
Note:
the appliance is not equipped with jug, please use yourself jug or coffee cup.
4.
Connect to power source, Press the power switch ON/OFF, the blue indicator is
illuminated.
5.
Press the coffee switch , the pump will pump water, when there is water flowing
out and close the pump by pressing the coffee switch , press the steam switch
selector and wait for a moment, the appliance begins to be pre-heated until the
inner lamp of coffee switch is illuminated, it shows the pre-heating is finished.
Press the coffee switch hand water will flow out.
6.
After water does not drop out any more, you can pour the water in each
container out then clean them thoroughly, now you can start brewing.
Note:
There may be noise when pumping the water for the first time, it is normal,
the appliance is releasing the air inside. After about 20s, the noise will disappear.
PREHEATING
To make a cup of good hot Espresso coffee, we recommend you preheating the
appliance before making coffee, including the funnel, filter and cup, so that the coffee
flavour can not be influenced by the cold parts.
1.
Remove the detachable tank and open the tank cover to fill it with desired
water, the water level should not exceed the
“
MAX
”
mark in the tank. Then
place the tank into the appliance properly.
2.
Select the steam mesh, Set steel mesh into metal funnel, make sure the tube
on the funnel aligns with groove in the appliance, then insert the funnel into
the appliance from the
“
Insert
”
position, and you can fix them into coffee
maker firmly through turn it anticlockwise until it is at the
“
Lock
”
position.
3.
Place an espresso cup on removable shelf.
