PJDK71351-03
MK71351
19/24
●
Radio Certification
MIC JAPAN(certification no 006-000680)
MK71351 complies with MIC JAPAN radio certification.(certification no:006-000680)
FCC
（
FCC ID: 2ACIJ71351
）
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1)this device may not cause harmful interference, and (2)this device must accept any interference received, including
interference that may cause undesired operation.
The regulatory label on the final system must include the statement: “Contains FCC ID: 2ACIJ71351" or using electronic
labeling method as documented in KDB 784748.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
The antenna used for this transmitter must not be collocated or operating in conjunction with any other antenna or transmitter
within a host device, except in accordance with FCC multi-transmitter product procedures.
The final system integrator must ensure there is no instruction provided in the user manual or customer documentation
indicating how to install or remove the transmitter module except such device has implemented two-ways authentication
between module and the host system.
OEM Responsibilities to comply with FCC Regulations
This module has been certified for integration into products only by OEM integrators under the following condition:
- The transmitter module must not be colocated or operating in conjunction with any other antenna or transmitter.
As long as the conditions above are met, further transmitter testing will not be required. However, the OEM integrator is still
responsible for testing their end-product for any additional compliance requirements required with this module installed (for
example, digital device emissions, PC peripheral requirements, etc.).
IMPORTANT NOTE:
In the event that any of these conditions can not be met (for example the reference trace specified in this manual, or use of a
different antenna), then the FCC authorization is no longer considered valid and the FCC ID can not be used on the final
product. In these circumstances, the OEM integrator will be responsible for re-evaluating the end product (including the
transmitter) and obtaining a separate FCC authorization.
Changes or modification not expressly approved by the party responsible for compliance could void the user’s authority to
operate the equipment.
IC
（
IC: 20971-71351
）
This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence.
L’exploitation est autorisée aux deux conditions suivantes :
(1) l’appareil ne doit pas produire de brouillage;
(2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en
compromettre le fonctionnement.
The regulatory label on the final system must include the statement: “Contains IC:
20971-71351".
Due to the model size the IC identifier is displayed in this manual only and can not be displayed on the modules label due to
the limited size.
CE
（
RED
）
MK71351 complies with the radio test requirements (EN 300 328 V2.1.1) ,which is based on the RE Directive.
EMC and Safety test that is required for the CE marking should be done in the final end-product.
