5 | Assembly
24 / 48
DURO-A RC
5.1
Personal Protective Equipment and Personnel Qualification
When working on and with the power chuck DURO-A RC, personal protective
equipment must be worn. The owner is responsible for providing personal pro-
tective equipment.
▪ Personal protective equipment must be in perfect condition when carrying
out work. Defective safety equipment is to be replaced immediately.
▪ Observe information on personal protective equipment posted in the work-
ing area.
▪ During
rotational operation
of the power chuck DURO-A RC,
no
protect-
ive gloves are to be worn! Hand protection is only to be worn during trans-
port, assembly and maintenance and as long as the power chuck
DURO-A RC is at a standstill.
Wear protective gloves
Wear safety goggles
Wear safety shoes
Work on and with the power chuck may only be carried out by qualified oper-
ating and specialist personnel (see
Qualification of Operating and Special-
).
5.2
Assembly on Intermediate Disk
Assembly of an intermediate disk is only necessary with conical holders.
§
Intermediate disk cleaned.
§
power chuck cleaned.
1.
Mount the power chuck on the intermediate disk in the correct position.
2.
Fix the intermediate disk to the power chuck with the fixing screws.
3.
Check radial and axial run-out of the power chuck on the check collar
and align if necessary.
4.
Check the jaw stroke with the capacitive proximity switch and re-adjust if
necessary.
5.
Check the device for correct operation.
6.
Tighten the fixing screws with the correct tightening torque (
the Tightness of Screw Connections [
).
ü
The intermediate disk is assembled.
