R&S
TSMX-PPS2
Getting Started
Getting Started 1515.7236.02 - 02
14
4.2 Preparations
The accessory re-closable Dual Lock Fastener®3M strip should be used for attaching
the device. This strip has to be cut to fit along the bottom side of the housing as shown
in
. The counterpart of the Dual Lock Fastener®3M should be cut to have
similar length.
Prior to applying 3M
TM
Dual Lock
TM
the bottom cover of the device should be cleaned
with warm water and dishwashing liquid. A 50:50 mixture of isopropyl alcohol (IPA) and
water may also be used.
•
To obtain optimum adhesion the bonding surface must be well unified, clean and
dry.
•
Remove the backing plastic from the Dual Lock Fastener®3M without touching the
adhesive strip. Align the tape to the desired position at the bottom side of the
device and apply pressure to the tape. Firm application pressure develops better
bond strength.
•
Turn the R&S TSMX-PPS with the Dual Lock Fastener®3M facing upwards.
•
Align the remaining strip and press both sides together unit you hear an audible
snap but don’t remove the backing plastic. The unit is now ready to be placed in
the vehicle according to the recommendations in the following section.
Figure 4-1: Dual Lock Re-closable Fastener
