Functional description
R&S
®
TS-PSM4
17
User Manual 1178.2796.02 ─ 01
●
Connection of voltage/current sources
●
Connection of test component loads
(original loads, simulated/electronic load)
●
Switch simulation
5.1.3 Application examples
5.1.3.1
Measuring current during active load
A typical application example for the use of a R&S TS-PSM4 module is connection of a
load to a voltage supply. In the example shown below (
connected to the COM lines on the rear of the R&S TS-PSM4 . This can be done via
the R&S TS-PRIO2 optionally installed in the R&S TS-PWA3 or the R&S TS-PK04
cable set in the TS-PCA3 chassis. The load is connected to the NO lines located on
the front of the R&S TS-PSM4 . The voltage supply’s force lines are introduced to the
load via two 16 A high power channels , whereas the sense lines are run via 2 A low
power channels.
Figure 5-1: Application example - measuring current with active load
R&S TS-PSM4
