Commissioning
R&S
®
TS-PIO2
31
User Manual 1506.7208.12 ─ 06
6 Commissioning
6.1 Installation of the R&S TS-PIO2 module
To install the plug-in module R&S TS-PIO2, proceed as follows:
●
Run down and power off the TSVP
●
Select a suitable front slot. For more information, see the operating manual for
„CompactTSVP R&S TS-PCA3“ or„PowerTSVP R&S TS-PWA3“, in both cases
Section “Permitted module configurations”.
●
Remove the front panel from the rear side of the TSVP chassis by slackening off
the screws
Damaged backplane due to bent pins
Bent pins may result in permanent damage to the backplane.
Check the backplane connector for bent pins!
Any pins that are bent must be straightened!
When module is connected, it must be guided with both hands and carefully pressed
into the backplane connector.
●
Press in the module applying moderate pressure.
●
The upper catch pin of the R&S TS-PIO2 module must be guided into the right
hole, while the lower catch pin is guided into the left hole of the R&S Com-
pactTSVP / R&S PowerTSVP housing.
●
The plug-in module R&S TS-PIO2 is correctly located when a distinct 'stop' can be
felt
●
Tighten the top and bottom screws on the front panel of the plug-in module R&S
TS-PIO2
Install the Rear-I/O R&S TS-PDC module as described in Section 6.2.
6.2 Installation of the R&S TS-PDC module
To install the plug-in module, proceed as follows:
●
The plug-in module R&S TS-PIO2 must have been installed beforehand.
●
Select the corresponding rear I/O slot for the R&S TS-PIO2 module.
Installation of the R&S TS-PDC module
