Rohde & Schwarz SMBVB-K362, User Manual

Page: 8 / 28

System configuration
R&S
®
SMBVB-K362, R&S
®
SMW-K362
8 User Manual 1178.9126.02 ─ 04
4 System configuration
This chapter describes everything you have to do before using the system for the first
time. Skip this chapter if you already have an operable system.
● Preparation of controller PC ......................................................................................8
● Preparation of instrument connection ....................................................................... 8
● Preparation of IVS connection .................................................................................. 9
4.1 Preparation of controller PC
To set up the controller PC, install the base software of R&S CMWrun. No smart card
and no licenses are required for the R&S CMWrun with the R&S SMx-K362 GNSS test
suite.
Refer to the sequencer user manual, section Installation.
Ignore the message indicating no license is found.
4.2 Preparation of instrument connection
1. For remote control of the instrument, configure the resource settings "Resources"
menu > "SCPI Connections". Configure the SCPI resource settings compatible to
the test instrument. For the control of R&S
SMBV100B, the entry with an alias
"SMBV" is used. For the control of R&S SMW200A, the entry with an alias SMW is
used.
Refer to the sequencer user manual, section Resources > SCPI Connections.
2. Configure measurement report settings.
For standard view of the measurement report, deselect "Treat "Ignored" as
"Failed"" in the configuration dialog of measurement report, tab "Fail Options".
To access the measurement report configuration dialog, proceed as follows:
a) To configure measurement report globally for all the tests, select "Resources"
menu > "Measurement Report..."
Preparation of instrument connection