DVB configuration and settings
R&S
®
SMW-K52/-K116
37
User Manual 1175.6778.02 ─ 19
Settings:
................................................................................................. 37
............................................................................................... 37
GSE Header Active
Inserts header information in the transport stream.
Remote command:
[:SOURce<hw>]:BB:DVB:DVBX:GHConfig[:STATe]
Label Type
Set the type of the used label field.
Remote command:
[:SOURce<hw>]:BB:DVB:DVBX:GHConfig:LTYPe
GSE Length
Sets the number of bytes following in the GSE packet.
Remote command:
[:SOURce<hw>]:BB:DVB:DVBX:GHConfig:GLENgth
Use, Fragment ID(Hex)
Indicates that a PDU fragment is included in the GSE packet.
Remote command:
[:SOURce<hw>]:BB:DVB:DVBX:GHConfig:FID:PATTern
[:SOURce<hw>]:BB:DVB:DVBX:GHConfig:FIUSe[:STATe]
Use, Total Length
Indicates the total length in bytes, calculated as follows:
"Total Length" = PDU length ("Data Length") + [2 bytes if "Use Protocol Type > On"] +
[6 (or 3) bytes if "Use Label > On"].
Extension headers are not supported and hence not included in the calculation.
Example:
If "Data Length = 4000", "Use Protocol Type > On" and "Use Label > Off", the "Total
Length = 4002"
Remote command:
[:SOURce<hw>]:BB:DVB:DVBX:GHConfig:TLENgth?
[:SOURce<hw>]:BB:DVB:DVBX:GHConfig:TLUSe[:STATe]
Use, Protocol Type(Hex)
Indicates the payload type carried in the PDU.
GSE header settings