Rohde & Schwarz R&S SMW-K116 DVB-S2/S2X, User Manual

Page: 96 / 106

Remote-control commands
R&S
®
SMW-K52/-K116
96 User Manual 1175.6778.02 ─ 19
Parameters:
<GHActive> 1 | ON | 0 | OFF
*RST:
1
Example: See Example "Configuring DVB-S2X signal in CCM mode"
on page 77.
Manual operation: See "GSE Header Active" on page 37
[:SOURce<hw>]:BB:DVB:DVBX:GHConfig:LTYPe <LType>
Set the type of the used label field.
Parameters:
<LType> integer
Range:
0 to 3
*RST: 0
Example: See Example "Configuring DVB-S2X signal in CCM mode"
on page 77.
Manual operation: See "Label Type" on page 37
[:SOURce<hw>]:BB:DVB:DVBX:GHConfig:GLENgth <GLength>
Sets the number of bytes following in the GSE packet.
Parameters:
<GLength> integer
Range:
1 to 4096
*RST: 1024
Example: See Example "Configuring DVB-S2X signal in CCM mode"
on page 77.
Manual operation: See "GSE Length" on page 37
[:SOURce<hw>]:BB:DVB:DVBX:GHConfig:FIUSe[:STATe] <FIUse>
Includes a PDU fragment in the GSE packet.
Parameters:
<FIUse> 1 | ON | 0 | OFF
*RST:
1
Example: See Example "Configuring DVB-S2X signal in CCM mode"
on page 77.
Manual operation: See "Use, Fragment ID(Hex)" on page 37
GSE header commands