Rohde & Schwarz FSW13, User Manual

Page: 729 / 1150

Remote Commands
R&S
®
FSW
729 User Manual 1173.9411.02 ─ 19
CALC:MARK:FUNC:POW:SEL OBW
//Activates occupied bandwidth measurement.
POW:BWID 99PCT
//Sets the percentage of power to 99%.
POW:ACH:BAND 21kHz
//Sets the channel bandwidth to 21 kHz.
POW:ACH:PRES OBW
//Optimizes the instrument settings according to the channel bandwidth.
POW:ACH:PRES:RLEV
//Determines the ideal reference level for the measurement.
DET APE
//Sets the trace detector to positive peak.
//--------------Performing the Measurement-----
INIT:CONT OFF
//Selects single sweep mode.
INIT;*WAI
//Initiates a new measurement and waits until the sweep has finished.
//---------------Retrieving Results-------------
CALC:MARK:FUNC:POW:RES? OBW
//Returns the occupied bandwidth.
11.5.6 Measuring the Spectrum Emission Mask
All remote control commands specific to spectrum emission mask measurements are
described here.
See also chapter 11.5.2, "Configuring Power Measurements" , on page 695.
● Managing Measurement Configurations ............................................................... 729
● Controlling the Measurement ................................................................................731
● Configuring a Multi-SEM Measurement ................................................................ 732
● Configuring a Sweep List ...................................................................................... 732
● Configuring the Reference Range .........................................................................747
● Configuring the Power Classes .............................................................................749
● Configuring MSR SEM Measurements ................................................................. 754
● Configuring the List Evaluation ............................................................................. 760
● Performing an SEM Measurement ........................................................................761
● Retrieving Results .................................................................................................761
● Example: SEM Measurement ............................................................................... 762
11.5.6.1 Managing Measurement Configurations
The following commands control measurement configurations for SEM measurements.
Configuring and Performing Measurements