Rohde & Schwarz FE50DTR, Manual

Page: 33 / 46

Operating the instrument
R&S
®
FE50DTR
33 Manual 1179.3180.02 ─ 02
To control the R&S FE50DTR with a vector signal generator
The R&S SMW controls the R&S FE50DTR using a secure socket layer (SSL)
control connection via LAN. The following step-by-step description explains how
the R&S
SMW locks the R&S FE50DTR to control the R&S FE50DTR exclusively.
1. Follow steps 1) and 2) of "To control the R&S FE50DTR with a vector signal
analyzer" on page 28.
2. In the external frontend network configuration dialog of the R&S SMW, set the
IP address or hostname and device ID of the R&S FE50DTR.
a) To access, select "System Configuration" > "External RF und I/Q" > "RF A"
> "External Instrument" > "Config".
b) Set the correct "IP Address" or "Hostname" and "Device ID".
The setting "Remote Channel" > "Frontend Connection" indicates that the
SSL control connection is used for frontend control.
3. Click "Apply and Connect".
A message displays, if the remote connection to the external frontend is
established or not.
Figure 6-1: Message displaying established remote connection
4. Configure the connection mode between external frontend and R&S SMW:
a) Click "Frontend Configuration".
Operating the R&S FE50DTR in Tx mode