Maintenance
59
User Manual (Hardware) | 2904.4460.02 - 04
Cleaning
CLIPSTER
Replacing a Power Supply Unit
Perform the following steps:
1.
Unplug the power cord from this power supply unit.
2.
Push the ejector to release the module.
3.
Pull the handle to remove the module out of the chassis.
4.
Slide the new unit into the power supply until it clicks into place.
5.
Connect the power source (power cord) to the newly installed power
supply unit.
The power supply unit has been replaced.
Cleaning
How to clean the product is described in "Cleaning the Product" on page 10.
Do not use any liquids for cleaning. Cleaning agents, solvents (thinners,
acetone), acids and bases can damage the front panel labeling, plastic parts
and display.
Storage
Protect the product against dust. Ensure that the environmental conditions,
e.g. temperature range and climatic load, meet the values specified in the
data sheet.
When completely inserted please observe that the ejector latch is truly in
place and locking the unit.
