Preparing for Use
R&S
®
SMC100A
17
Quick Start Guide 1411.4077.62 ─ 07
IEC 625/IEEE 488
IEC-bus (IEEE 488) interface for remote control of the instrument.
See also
Chapter A.1, "GPIB Bus Interface"
on page 72 and chapter "Remote Con-
trol Basics" in the Operating Manual.
Note:
In order to avoid electromagnetic interference (EMI) caused by open lines,
always terminate any connected IEC-bus cable with an instrument or a controller.
PULSE VIDEO
Output of internal pulse generator signal or external pulse signal fed in via the PULSE
EXT connector (video signal).
PULSE EXT / INST TRIG
●
PULSE EXT
Input of external pulse signal or input of external trigger/gate signal for internal
pulse generator.
See also chapter "Pulse Modulation" in the Operating Manual.
●
INST TRIG
Input for external trigger for sweeps.
See also chapter "Sweep mode" in the Operating Manual.
REF OUT
Output of internal reference signal.
REF IN
Input for external reference signal.
LAN CONNECTOR
Ethernet interface
●
For integrating signal generators in a network
●
Remote control of signal generator
●
Remote access to the signal generator
●
Firmware update
See also:
●
Chapter 2.6, "Setting Up a Network (LAN) Connection"
●
chapter "Remote Control Basics" in the Operating Manual
OCXO
Oven-controlled reference oscillator (option R&S
SMC-B1)
The OCXO generates a very precise 10 MHz reference signal. It needs some minutes
of warm-up time to reach its nominal frequency.
Refer also to the data sheet for detailed information.
Rear Panel Tour
