HRT82MF-CH Installation Guide.doc
2018-09-21
9/11
CSN Number of
Bytes
0..8
The parameter specifies how many bytes of read only Chip
Serial Number (CSN) is used in UID card number.
Mifare Classic Settings
Card number
CSN, MSN.
SSN
When CNS is selected then UID includes only this number.
When MSN or SSN is selected then it is possible to use
administrator defined UID. It is also possible to define UID
consisting partially of CSN and MSN or SSN.
Format
BIN, HEX
ASCII
Card number format. When BIN is selected then bytes from
card correspond to UID number. When HEX ASCII is
selected then bytes from card correspond to UID in ASCII
hexadecimal format.
LSB
0..15
The location of MSN or SSN first byte.
MSB
0..15
The location of MSN or SSN last byte.
Sector ID
0..39
Sector number with SSN. For MSN this setting is disabled.
AID
0000..FFFF
AID number in MAD sector which defines sector with MSN.
For SSN this setting is disabled.
Block ID
0..14
Block number in the sector with MSN or SSN.
Key Type
A, B , Roger
Type of key used for reading MSN or SSN.
Key
00000000000..
FFFFFFFFFFFF
Six bytes key used for reading MSN or SSN.
4.2 Firmware update
HRT82MF-CH firmware can be updated with RogerVDM (available at
) after
connection to RUD-1 communication interface.
Firmware update procedure
1.
Connect device to RUD-1 communication interface according to fig. 6
2.
Install and start RogerVDM software
3.
Close
Select Device
window
4.
In top menu select
Tools->Update firmware
5.
In the opened window select device, port with connected RUD-1 and specify path to firmware
file (*.hex) – see fig. 9
6.
According to displayed message place jumper on FDM pins and restart the device (place and
remove jumper on RST pins or switch power supply off and on)
7.
Select
Update
button
8.
After firmware upload remove jumper from FDM pins and reset device (place and remove
jumper on RST pins or switch power supply off and on)
