EN
19 INSTALLING THE BI/BLED/8 LED FLASHING LIGHT (fig. 26-27)
The BI/BLED/8 flashing lamp unit is factory supplied already pre-installed in the head [A], packaged separately inside the BIONIK package.
1. Insert the connector [
B
] in the LIGHT terminal of the control unit.
2. Refer to the control unit manual for the flashing lamp unit settings.
3. Fasten the cable grommet [
C
], making sure it is positioned correctly.
4. Position the head [
A
] on the barrier.
5. Tighten the four fastening screws [
Z
].
In case of replacement:
1. Disconnect the mains and battery power supplies (if applicable).
2. Unscrew the four screws [
Z
] that fasten the head [
A
] to the barrier.
3. Lift the cable grommet [
C
].
4. Disconnect the connector [
B
].
5. Remove and overturn the head [
A
].
6. Remove
the
BI/BLED/8
flashing lamp unit [
D
] from the diffuser.
7. Insert the new LED circuit in the diffuser, paying attention to the installation direction (fig. 27).
8. Insert the connector [
B
] in the LIGHT terminal of the control unit
CTRL
.
9. Refer to the control unit manual for the flashing lamp unit settings.
10. Fasten the cable grommet [
C
], making sure it is positioned correctly.
11. Reposition the head [
A
] on the barrier.
12. Tighten the four fastening screws [
Z
].
13. Reconnect the mains and battery power supplies (if applicable).
B
C
x4
Z
A
C
D
D
D
A
LED LIGHT
26
27
