Rofin PowerLine E Air 10, Maintenance And Integration Manual

Page: 28 / 78

Maintenance
18 PowerLine E Air
2.1 Changing the filter mat/s
The components in the 19" plug-in for electrical components are cooled by a separated routing of
air flow.
Depending on the laser, the 19" plug-in for electrical components has one or two filter mats,
respectively, to protect it from soiling.
PowerLine E Air 10
PowerLine E Air 25/ 30
Attention
1
– Change the filter mat/s at least once a year, or more regularly depending on the level of
soiling.
– Make sure that the filter mats remain sufficiently pervious to ensure the required heat
exchange.
– Dispose of used filter mats as commercial waste.
– Exclusively use the filter mats listed in the "Spare Parts" chapter (see Section "3, Spare parts"
on page 25).
– Never operate the system without filter mats. Non-compliance may affect the cooling
performance and cause damage to the components inside the 19" plug-in for electrical
components.
Attention
1
Switch the laser system off properly.
A white filter mat is located in the front behind the
grille in the 19" plug-in for electrical components.
FIG. 22 Filter mat in the 19" plug-in for electrical
components
One white and one black filter mat is located in
the front behind the grille in the 19” plug-in for
electrical components.
1
Attention
Make sure to correctly position the black and
white filter mats in the front behind the grille in the
19" plug-in for electrical components
.
FIG. 23 Filter mats in the 19" plug-in for electrical
components
white filter mat
black filter mat on the left side /
white filter mat on the right side