UNPACKING AND SETTING UP
Unpacking and Assembly
●
Unpack the tile saw and inspect
for any damaged parts.
●
Install the legs in the sockets at the under
side of the water container and fasten with
the knobs. Markings show the right
position.
●
Level the tile saw by adjusting the
legs in the sockets and make sure its
stable.
●
Release the transportation lock.
Setting the Cutting Depth:
●
By loosening the knob the saw head can
be positioned at the desired height.
The saw head is tightened by a spring and
may accidentally jump up when the knob
is loosened.
Cooling System
Operating the water pump without a sufficient
supply of water may result in pump damage.
●
Place the plug in the drain of the water
container.
●
Fill the container with water until the
water pump is completely submerged.
Connecting to Power Supply
Before connecting the machine make sure that:
●
the line voltage corresponds with the data
on the machine’s specifications plate,
●
there is a grounded power supply,
●
the extension cord’s meets criterea as
mentioned in the table on page 10.
Motor Protection
The motor is equiped with a thermal safety switch
for protection against an overload. When the
motor gets overheated, the switch falls back into its
initial position and can only be switched on again
after the motor has cooled down.
PAGE 12
RODIA 3515RS OPERATING MANUAL V11/2006R1
Transportation Lock
