MAINTENANCE & TROUBLESHOOTING
The machine does not work.
Water does not flow at the Blade
while the pump is running.
Motor is not running properly.
Pump is not running.
Bad cutting alignment.
The power supply cable is
damaged or not properly con-
nected.
No voltage in the power
outlet.
Start Switch is damaged.
The sprayers are clogged.
The water level in the waterbin
is not sufficient. The pump is not
totally submerged.
Water valve is closed.
Water may have seeped through
inside the motor.
Capacitor is damaged.
Motor bearing are damaged.
The impeller or suction filter of the
pump is damaged.
No proper connection of the
power cable.
Machine is not level.
Unlevel working surface.
Improper or glazed Diamond
Blade.
Press the plug firmly in the power
outlet. Check the power supply
cable.
Have the power outlet
checked.
Have the Switch replaced.
Clean the sprayers
Fill the waterbin with clean water
until the pump is totally sub-
merged.
Open the valve.
Unplug the power cable and con-
sult your local dealer.
Unplug the power cable and con-
sult your local dealer.
Unplug the power cable and con-
sult your local dealer.
Replace damaged parts.
Have the connection checked.
Loosen the screws for the legs.
Pick up the machine a little bit on
one end. Let the machine down
again nd tighten screws. Do the
same procedure for the other end.
Machine should now be level
Make sure the machine is placed
on a level surface.
Replace or dress the Diamond
Blade.
PROBLEM
CAUSE
SOLUTION
RODIA 3515RS OPERATING MANUAL V11/2006R1
PAGE 17
