13
Backpanel with connectors
K
L M
A
B
Q
P
N
O
E
D
C
F
G
H
U
W
V
I
J
S T
R
www.rodec.com
RODEC
Made in Belgium
Professional
Audio Equipment
WARNING
DISCONNECT POWERCORD
BEFORE OPENING
P S
E
A)
Power switch
Controls the supply of AC power to the set. One push turns the mixing panel on, a second push
turns it off.
Attention!
By turning off this switch, the mixing panel is in stand-by mode. At that moment
the mixing panel will still consume electricity from the mains net. The power
cord has to be unplugged from the power inlet to shut down all power.
B)
Effects IN/OUT 1
In- and output to connect effect equipment to the music signal. The signal that runs through this
connector is controlled by the input channel effects assign potentiometer (5) or main mix effects
assign potentiometer (26). Internally linked when JACK is not inserted. Sensitivity 775mV.
C)
Symmetrical monitor output
Additional output up to 1.55V controlled by monitorfader (20). The DJ-microphone signal does
not appear on this output.
D)
Symmetrical master output 2
Symmetrical output to connect power-amplifier or loudspeaker-processor. The output level can
be manipulated with master fader 2 (19) from 0 to maximum (1.55V).
E)
Symmetrical master output 1
Symmetrical output to connect a power-amplifier or loudspeaker-processor. The output level
can be manipulated with master fader 1 (19) from 0 to maximum (1.55V).
F)
DJ microphone input
Balanced microphone input with a sensitivity of 4.2mV, with XLR-JACK combination connector.
G)
Effects IN/OUT
Input and output to connect effect equipment to the microphone channel. If there is no plug in
the JACK connector, the microphone channel works normally, if there is a plug inserted in the
JACK, the internal link is interrupted. The sensitivity of this IN/OUT connection is 775mV.
H)
Ground-terminal
Terminal to connect the ground wire of the vinyl turntable.