•
Pressing the Esc key restarts the entire authentication process.
CHANGING YOUR ADMINISTRATIVE PASSWORD
The Admin password provides the only means to user password recovery on X5. It is
recommended that you change the default factory Admin password to another one that only
you know. The default factory Admin password is “
87654321
”.
To change your Admin password, follow these steps:
1.
Power up X5 by connecting to the host via USB or FireWire. Ensure the STATUS LED blinks
once.
2.
Press the
Change Pin
button, followed by the
‘0’
button.
3.
Press
Enter
. The Status LED will blink three times.
4.
Enter the
current 8-digit Admin password
and press
Enter
. The Status LED blinks twice to
notify that you may press the new Admin password.
5.
Enter the
new 8-digit Admin password
and press
Enter
. The Status LED blinks twice to
notify that you may press the confirmed new Admin password.
6.
Enter the
new confirmed 8-digit Admin password
and press
Enter
.
7.
The Status LED will blink three times and there will be two ‘beep’ sounds if the change is
successful.
8.
Remove and reconnect the USB cable to exit the Administrative mode.
If you have mistyped your password, press the
Esc
key at any time to restart the entire
authentication process.
Note:
•
X5 only accepts 8-digit Admin password.
If a shorter or longer password is entered, the
Error LED will blink continuously. Press the Esc button to restart the authentication
process again. You will need to restart the entire process from step 2.
•
You will NOT be able to connect to the hard disk via the presentation of the
Admin password. To do so, remove and reconnect the USB cable to exit the
Administrative mode and proceed to enter the user password to authenticate
to X5.
ROCSECURE
|
AMPHIBIOUS X5 user manual
Page | 23