User guide
GSM500.GC
Issue 1.00
Page 8
Installation
Ensure that at the installation location a power plug in available nearby. For the wall
installation you can use the screws delivered with the unit.
It is very important that the GSM500.GC unit has all time the best GSM signal to
avoid disturbances during operation time. Before you install the device at his fi nal
position be sure that it is the best spot you can fi nd. To do this use an mobile phone
with a SIM card of the same provider that you are going to use with the GSM500.
GC and try at the spot you are going to use to setup a communication. If during the
conversation you will notice disturbances or interruptions you will have to look for a
better position.
Use close to explosive material
The GSM500.GC may not be used or installed within fuel depots, chemical facilities
or within areas where explosive gas is present or used. The installation and use of
this device within such enviroments can be done only following the highest security
advices.
Usage
Do not use the GSM500.GC in contact with human body. Do not touch the antenna
during opertation if not specifi cally required. Use only original and approved spare parts.
SIM card installation
For the installation of the SIM card be sure that the devices is
SWITCHED OFF
! The
SIM card has to be placed into the specifi c slot. The card should have the PIN code
disabled. If a PIN code is required then you have to program it, using a mobile pho-
ne, with the code "0000". After installation and frist activation the device will change
the PIN code with a new, random generated one.
PLEASE NOTE!
If you change the SIM card switch all time the POWER OFF!
Ensure hat the PIN code of the SIM card is disabled or changed to "0000" with a
mobile phone BEFORE you install it into the device.
If the SIM card is changed ensure that the new card has the PIN code disabled
or changed to "0000". If the new card has the PIN "0000" you have to restart
the device with factory default data using the reset button to ansure a new
random code is programmed.
Keep the PIN and PUK number for the SIM card available during this procedure.
If you change the SIM card with a new one and you are using data connectivity
you must unregister and reregister the device to the VNDNET Server.
