6
Eastwood Technical Assistance: 800.343.9353 >> [email protected]
To order parts and supplies: 800.343.9353 >> eastwood.com
3
READ INSTRUCTIONS
• Thoroughly read and understand these product instructions before using
this tool. Failure to follow all warnings can result in tool damage or serious
physical injury.
• Keep these product instructions for future reference.
EYE INJURY HAZARD!
• Rapidly moving surfaces can eject metal particles, dirt and debris at
high velocity. Always wear ANSI approved eye protection when
operating this tool.
HEARING DAMAGE HAZARD!
• This Rockwood Pneumatic Tool emits high sound levels while operating.
Use ANSI approved ear protection when operating.
BURSTING HAZARD!
• Do not exceed 90 psi (6.2 bar) of tool inlet pressure. Permanent tool
damage and/or explosion could occur and cause personal injury.
DANGER indicates a hazardous situation which, if not avoided, will result in death or serious injury.
WARNING indicates a hazardous situation which, if not avoided, could result in death or serious injury.
CAUTION used with the safety alert symbol, indicates a hazardous situation which, if not avoided,
could result in minor or moderate injury.
NOTICE is used to address practices not related to personal injury.
SAFETY INFORMATION
The following explanations are displayed in this manual, on the labeling, and on all other information
provided with this product:
PROBLEM
CAUSE
SOLUTION
Tool Doesn’t
Respond to
Trigger
Depression
Insufficient volume
of air (CFM) to
operate tool
Verify sufficient air supply to tool.
(4 CFM @ 90 PSI minimum requirement)
Moisture or other
contamination
in air supply
Check for moisture in air line and tool air inlet
Tool
Performance is
Slow or Sluggish
Insufficient volume
of air (CFM) to
operate tool
Verify sufficient air supply to tool
(4 CFM @ 90 PSI minimum requirement)
Moisture or other
contamination in
air supply
Check for moisture in air line and tool air inlet
Air Motor is lacking
lubrication
Stop use immediately and add air tool oil
directly to air inlet
Tool Cycles
Excessively
but Air Tool Bit
Moves Very Little
or Not at All
Air Tool Bit has
worked loose from
Spring Retainer
Stop use immediately and re-attach spring to
Air Tool Bit Shank
TROUBLESHOOTING
