LITHIUM MINI DRILL
EN
10
SyMBoLS
TECHNICAL DATA
oPERATING INSTRUCTIoNS
NoTE:
Before using the tool, read the
instruction book carefully.
BEFoRE PUTTING INTo oPERATIoN
1. RECHARGING BATTERIES
a) CHARGING THE BATTERy
The battery charger supplied is matched to the Li-ion
battery installed in the machine. Do not use another
battery charger.
The Li-ion battery is protected against deep
discharging. When the battery is empty, the machine
is switched off by means of a protective circuit: The
tool holder no longer rotates.
In a warm environment or after heavy use, the battery
pack may become too hot. Allow time for the battery
to cool down before recharging.
b) IMPoRTANT NoTES FoR CHARGING THE BATTERy
The battery in your new tool is not charged when it
leaves the plant. Therefore it must be charged for 1
hour before using the first time!
NoTE:
If the battery pack is very hot you must remove
your battery pack from the charger and allow your
battery pack to cool first to ambient temperature and
then recharging can be started.
To prevent damage to the Battery Pack, when charge
runs out, please charge the battery to reach full or no
less than half charge before storage.
If the tool will not be used for long periods of time,
charge the battery every 3-6 months
c) CHARGING (See Fig. A)
1) Plug the charger into an appropriate outlet. The
light (a) will be green.
2) Insert the Battery Pack (7) into the charger,
the light (b) will be red and flash to indicate the
charging process has started.
3) On completion of charge, the light (a) is green, and
light (b) will illuminate red, and won’t flash. The
Li-Ion
Li-Ion
To reduce the risk of injury, user must read
instruction manual
Warning
Wear ear protection
Wear eye protection
Wear dust mask
For indoor use only
Do not burn
Batteries may enter water cycle if disposed
improperly, which can be hazardous
for ecosystem. Do not dispose of waste
batteries as unsorted municipal waste.
Li-Ion battery. This product has been
marked with a symbol relating to ‘separate
collection’ for all battery packs and
battery pack. It will then be recycled or
dismantled in order to reduce the impact
on the environment. Battery packs can
be hazardous for the environment and
for human health since they contain
hazardous substances.
C-tick marking
Fuse
T2A time lag fuse with rated current of 2A
Positive terminal
Negative terminal
Battery voltage:
Charger voltage:
No load speed:
Charging time:
Collet size:
Machine weight:
12V
100-240V~ 50Hz
0-22000 /min
1 hr
Ø 2.3 mm / Ø 3.2 mm
0.5 kg
