6-2
Installing and Operating the SP200 AC Drive
The following sections describe the four-character display, the Run and Program
LEDs, and step-by-step operation of the keypad.
6.1
Display Description
The keypad has a four-character display which is used to show parameter numbers
and parameter values. The keypad monitors its connection to the drive and will display
if this connection fails due to electrical noise or a hardware failure.
If the drive faults, the full display will flash to indicate the presence of the fault, and the
fault code will be displayed. The
,
, and
keys can still be pressed to change
parameter number and value, but the display will continue to flash until the fault
condition is reset. If the fault condition is reset without the operator changing the
parameter number or value, the display will return to the parameter value that was
selected prior to the occurrence of the fault.
6.2
Run and Program LED Descriptions
The keypad has two LEDs which indicate the drive status.
Table 6.1 – Run LED
Run Indicator Status
Description
Off
The drive is not running.
On
The drive is running.
Flashing
The drive is changing direction.
Table 6.2 – Program LED
Program Indicator Status
Description
Off
The drive is in monitor mode.
On
The drive is in program mode.
