Rockwell Automation Reliance electric GV3000/SE, User Manual

Page: 34 / 112

4-4
GV3000/SE Operator Interface Module (OIM) User Guide, Version 2.0
•
The parameter type is INPUT. This means you can change the value.
•
The save type is RETENTIVE. This means the parameter is saved through a power
cycle.
•
The units of measure are RPM. If units of measure do not apply, this line is blank.
For full descriptions of parameters, see the software I/M.
4.1.3 Accessing the Parameters
Parameters are accessed through the menus. The menu paths to get to parameters
are listed in Appendix B.
Some parameter options are only available if the appropriate option is installed. If a
parameter is not available, the cursor changes to the locked symbol ( ).
If you exit program mode when you are in a parameter entry screen, that menu or
parameter is displayed again when you return to program mode.
The basic steps for accessing a parameter are provided here. A detailed example
follows.
Step 1. Select the menu that contains the parameter.
Step 2. Press . The next menu or parameter list is displayed. Repeat steps 1
and 2 for each menu until the parameter list you want is displayed.
Step 3. Move the cursor to the parameter you want to change. Press .
The parameter entry screen is displayed. In this screen, you can look at or
change parameter values.
Example
The following detailed steps use parameter JOG RAMP ACCEL TIME (P.021) as an
example. To select JOG RAMP ACCEL TIME:
Step 1. At the Main Menu, use to move the cursor ( ) until it points to Speed
Control as shown in figure 4.5.
Figure 4.5 – Selecting the Speed Control Menu