Roc Hobby Beechcraft, Operating Manual, Page: 16 / 28

page12
Assemble the plane
The receiver connection Install the battery
1. Plug the leads to the receiver as the
diagram shows.
1. Open the wind shield by raise the tape
in front edge of the shield.
2 . Tuck the wire leads into the recessed
cavity at the rear end of the servo hatch.
Make sure the wires do not interfere with
the servo arm moving path.
Receiver
Throttle
Channel-1
— Aile
Channel-2
— Elev
Channel-3
— Thro
Channel-4
— Rudd
Channel-5
— Gear
Aux
1
2
3
Aileron
Elevator
4 Steering/Rudder
5 Landing gear
6
Flaps
2 . Take the magnet attached front seats
out and slide the battery in as the picture
shows with the cable end towards the back
seats till it is fully sits in the cockpit.
3
2.2
1
1.1
1.2
2.1
For More Info Vist: www.motionrc.com