Install the linkage rod
Mount the lower wing
1.
Put the Z-bend end of the linkage into
the desired servo control horn hole.
It is a tight fit and should allow the
linkage to move just slightly within the
hole to avoid binding up.
page8
Assemble the plane
2.
Snap the clevis into the surface control
horn.
1.
Plug the wire leads from the LED and
the retract to the four way harness, the
flaps servo leads with the label Ch6 go
to the two way harness with the orange/
white cable on the same port.
3.
The provided piece of fuel tubing keeps
the clevis closed during flight. Secure all
the linkages the same way.
Note:
Do not over slide the securing
tube or it will impede the movement
of the surface control horn.
2.
Thread the harness of the lower wing
from the lower wing bay bottom to the
servo hatch.
3.
Sit the wing properly into the bay, make
sure to slightly pull the harness from the
servo hatch at the same time to avoid
any tangling to prevent the wing from fully
installation.
1
2
3
1
2
3
For More Info Vist: www.motionrc.com
Summary of Contents for Beechcraft
Page 1: ...Email info motionrc com Http www motionrc com...
Page 2: ...Beechcraft...