11
20/03/2018
• MINI BOWL BLADE (Cutter only)
A special tool designed to
make it easier to remove
the blade assembly from
the mini bowl is supplied
with the machine.
• SCRAPER ARM (Blixer
®
only)
The scraper arm is equipped with rubber pieces
which are wearing parts.
They should be replaced occasionally to always
ensure an optimum efficiency of the scraper arm.
These pieces are easy to dismantle and to reassemble.
Rubber pieces to
scrape the lid
Rubber piece to
scrape the bowl.
• BLADES
Only the blades on cutters R 8/R 10/R 15 and R 20
can be sharpened.
It is strongly recommended, after each use, to give
the blades a quick sharpen with a sharpening steel,
especially after cutting parsley.
They should then be sharpened properly once a
month with the very fine whetstone that comes with
the appliance.
The quality of the cut depends mainly on the sharpness
of your blades and the degree of wear.
The blades are actually wearing parts, which should
be replaced occasionally to ensure consistent quality
in the final product.
• SEAL
The seal on the motorshaft should be lubricated
regularly using a food safe lubricant.
In order to keep the motor completely watertight, it is
advisable to check the gasket regularly for wear and
tear and replace if necessary.
Replace shaft seals each 3 to 6 months. Lubricate
seals with food grade grease.
• LID SEAL
The lid is designed to be completely watertight. In
order to ensure that it remains that way, you may
have to change the seal occasionally, depending on
how regularly you use your machine.
If you do not use your machine regularly, between
uses it is advisable to leave the lid open to preserve
all these features.
DIAGNOSTIC SYSTEM
Your appliance is equipped with a green light that
indicates the operational status of your machine:
-
no light
: see paragraph 1.
-
flashing light
: see paragraph 2.
-
steady light
: your appliance is ready to run.
R E M E M B E R
Always switch your machine off before carrying
out any cleaning or maintenance,
All repair and maintenance work must be
carried out by a qualified technician.
R E M E M B E R
The control system requires the lid be opened
and closed, once after switching your appliance
on.
This sequence will check the correct operation
of the lid arm safety switch. At this stage, if all
the conditions are met for operation, the light
will stop flashing and stay on.
Summary of Contents for Blixer 10
Page 18: ...45 20 03 2018 TECHNICAL DATA...
Page 19: ...62 20 03 2018...
Page 20: ...63 20 03 2018...
Page 21: ...64 20 03 2018...