SPIROR HP - DR
6.
ABOUT THE USE
6.1. RECOMMENDATIONS FOR OPERATION AND USE
‒
Before performing any operation, the operator must make sure that he/she understood the "Instructions
for use".
‒
When using the machine for the first time, the operator must read the manual and identify the controls
and simulate some operations, especially the start-up and shutdown.
|
Important
Accident frequency derived from machine use depends upon many factors that cannot always be foreseen and
controlled. Some accidents can depend upon unforeseeable environmental factors; others depend especially
upon the user's behaviour. In addition to being authorised and appropriately informed, on first use personnel
must simulate some manoeuvres to identify the main commands and functions. Only carry out the operations
foreseen by the manufacturer and do not tamper with any device to obtain performances other than those
provided. Before use, check that the safety devices are correctly installed and efficient. Users, in addition to
striving to satisfy these requirements, must apply all the safety regulations and carefully read the descriptions
of the controls and start up.
6.2. CONTROL DESCRIPTION
IG)
Master switch
Turns the power supply on and off.
Position
"0"
(OFF) indicates that the
machine is not powered.
Position I (ON) indicates that the
machine is on.
A)
Emergency button
Immediately cuts off the power supply in
emergency situations stopping the
machine.
The button is of the mechanical retention
type; to reset, rotate the button as
indicated by the arrow.
|
Important
After the emergency button enablement, you must press the reset button to enable the automatic cycle.
B)
STOP push-button
By pressing the button, the automatic wrapping cycle is stopped with the units in phase.
C)
Start button
Press the push-button to enable the automatic work cycle.
D)
“Reset” Switch
Press the machine push-button to put the machine in phase.
Press to reset the machine before restarting it after an emergency stop or restart it after a shutdown
with the disablement of the power supply.
E)
"touch screen": operating terminal: to display and set production parameters.
6.3. DISPLAY IN OPERATION
The operative panel is a screen that lets the user set working parametres and check all machine operating
condition. It is equipped with a display allowing to activate all the various functions simply by "touching" what
is written on it. Each page contains scroll keys to move from one page to the other. If necessary. It contains
keys which allow to set the parameters, executing some commands, etc.
English
52/95
Summary of Contents for SPIROR DR
