69
REPLACEMENT INFORMATION
ENG
9. REPLACEMENT INFORMATION
9.1. RECOMMENDATIONS FOR REPLACING MACHINE PARTS
-
Before performing any operation, the authorised operator must make sure to have understood the “Instructions
for use”.
-
Carry out the interventions with all the safety devices enabled and wear the required PPE.
-
Demarcate the surrounding areas and put in place adequate safety measures, as provided for by the standards
on workplace safety, in order to prevent and minimise the risks.
-
Do not carry out interventions that are not described in the manual but contact an service centre authorised by
the Manufacturer.
-
Do not dispose of materials, polluting liquids and the waste generated during the interventions into the
environment but dispose of them according to the standards in force.
-
Replace the components only with original spare parts or parts with similar design and construction features.
The use of similar but non-original spare parts may result in improper repairs, altered performance and economic
damage.
-
Safety components and/or devices must be replaced only with original spare parts to preserve the safety level
required.
Important
Before performing any maintenance operation, activate all safety devices provided and evaluate whether
it is necessary to inform the personnel operating on the machine and the personnel nearby.
In particular, demarcate the neighbouring areas to prevent access to the devices that could, if activated,
cause unexpected hazardous conditions posing a risk for people’s safety and health.
When replacing worn parts, use only original spare parts.
The Manufacturer is not responsible for any damage to property or injuries to people caused by the use
of non-genuine spare parts or which may result from repairs not authorised by the Manufacturer.
When ordering new spare parts, follow the instructions given in the spare parts catalogue.
9.2. REPLACING THE ROTARY TABLE WHEELS
1.
Loosen the screws (A).
2.
Fit the eyebolts (B) and remove the upper plate (C).
3.
Lift the table and place it on the ground.
4.
Replace the wheels (D).
5.
Reposition the table on the base and fasten it with the screws.
6.
Restart the machine to check its proper operation.
Caution - warning
Before restarting the machine, check that there are no tools or other material near the moving parts.