Robmex VM 050 D400-3-E, Manual

Page: 5 / 45

5
GENERAL WARNINGS
This device is not intended for use by persons (including children) with physical, sensory or mental
disability, or by persons lacking experience or knowledge, unless they have received from a person in
charge of their safety adequate supervision or preliminary instructions on how to use the device. Children
should be supervised to ensure that they do not play with the appliance.
This unit can be used by children of not less than 8 years and people with reduced physical, sensory or
mental capabilities or without experience or knowledge if they are properly supervised or if the instructions
for using the device safely have been given and if the risks are taking into account. Children must not play
with the device. Cleaning and maintenance must not be done by children without supervision.
CAUTION ! Heavy item, handle with care:
1. Install the appliance in a room which is protected from frost. If the appliance is damaged because the
safety device has been blocked, it is not covered by guarantee,
2. Make sure that the wall on which the appliance is mounted can support the weight of the appliance
when filled with water,
3. If the appliance is to be fitted in a room or location where the ambient temperature is higher than 35°C,
provide sufficient ventilation,
4. When installed in a bathroom, do not install the appliance in volumes V0 and V1 (See fig. 1, p.2). If the
water heater is to install above living space, fit a retaining tank with drain to the sewer system. Place
the water heater in a place with easy access,
5. If PER pipes are used, the installation of a thermostatic regulator on the output pipe of the device is
strongly recommended. It will be set according to the performance of the material used.
6. Installation of a vertical or horizontal wall mounted device: To allow the replacement of the heating
element leave a free space of 300mm between the tube ends and the wall or fixed furniture.
7. Switch off the power before removing the cover, to avoid any risk of injury or electric shock.
8. The installation must be equipped, upstream of the appliance, with a bipolar cut-out device (fuse,
breaker switch) respecting local regulations (30 mA earth-leakage breaker).
9. If the supply cord is damaged, it must be replaced by a special cord or assembly available from the
manufacturer or the after sales service.
10. Mandatory installation of a safety device in a frost free location (or any other new device which limits
the tank pressure) to 7 or 9 bar (0.7 or 0.9 MPa) according to the nominal pressure, with a size of 1/2"
in the input of the water heater, respecting the local regulations
11. Operate regularly the discharge of safety device to prevent scaling and check that it is not blocked.
12. Hydraulic accessories should not be located between the safety valve and the cold water inlet. A
pressure reducer (not supplied) is required when the water supply pressure exceeds 5 bar (0,5 MPa)
and will be fitted on the main supply.
13. Connect the safety device to an unpressurised outlet pipe in a frost free location, with a continuous
slope to evacuate water during heating up or draining the water heater.
14. The pipes used must support 10 bars (1 MPa) and 100 ° C.
15. To drain the device: Switch off the power and the supply of cold water, open the hot water faucets and
manipulate the safety valve. To drain under sink water heater disconnect the hydraulic connections and
return the device.
16. The products described in this manual are subject to changes at any time to be in accordance with
technology and standards. The devices comply with electromagnetic directives 2004/108/EC and Low
Voltage 2006/95/EC.
17. Do not dispose your water heater in the garbage, but hand it to a place assigned for this
purpose (collection point) where it can be recycled.
EN