24
V0818
Z500-serie
English
Deutsch
Attention: cleaning and maintenance of the sliding table
It is vital to regularly blow away the saw- and other dust, collected between the sliding table
and the bearing cage. Push the sliding table to the end, to get a better reach towards the rails,
the bearing cage and gliding tracks. Oil serves to lubricate the sliding rails and is an extra
guarantee of good use and function.
Always use the handle to move the sliding table!
Fig.14A
Fig.14B
Mounting of the cross-cut table
(Fig.17)
The cross-cut table can be mounted on the sliding table as follows: make sure that both mounting
brackets are well placed in the lateral groove of the sliding table.
The locking itself is done with the two locking handles (1). Make sure the cross-cut table rests well on
the vertical post of the telescopic arm. The machine serves only to put the cross-cut table at the back
of the sliding table, with a maximum at the centre.
The cross-cut table and fence are factory set at 90° to the saw blade but if for some reason this is not
the case and not exact anymore, the 90° angle setting adjustment is done by loosening the 4 bolts
(2) and shifting the complete cross-cut table. Make sure these 4 bolts are well tightened after the
adjustment is done. The cross-cut table can only be mounted at the end of the sliding table. To put it
more forwards (max. in the middle), use the optional longer telescopic tube Z0482.
Fig.17
