Robland HX TZ, User Manual

Page: 23 / 98

22
V0212 HX SERIES
–
English
–
Deutsch
Use of the cross-cut fence
(fig. 15)
The measuring tape of the cross-cut fence is factory set. To make sure the measurements correspond
to the index, do the test where you place the 2 flip-stops on a certain distance and check if the
obtained distances are the same as the distances of the index.
Lock the flipper at a defined length and cut off a sample.
Now take the exact measurements of the sample.
To calibrate the index, remove the 2 handles of the fence on the table, without removing the fence from
the outrigger table. Inside the 2 locating pins of the fence you will find a socket cap screw.
Loosen the two socket caps, which enable you to move the fence to equalize the measurements with
the index.
Tighten the two socket cap screws again and place the 2 locking handles. To calibrate the index on the
telescopic part, loosen the 2 socket caps holding the short part of the fence on the square telescopic
tube. Now repeat above in order to calibrate the scale on the telescopic part of the fence.
Tighten the two socket cap screws again.
Fig.15
Drawing of the splinter protection
(fig. 16)
The fence is equipped with a splinter protection. When the splinter protection is damaged, it should be
replaced. It can be replaced by a piece of wood that has the following dimensions:
Fig.16