ROBINHOOD ST9000W, Installation And Operating Instrictions, Page: 3 / 10

3
Securing the Workstation
1. Remove the black plastic grommet
A
. Using scissors or wire cutters, cut the top lip of the grommet, squeeze
and remove. Used for transport only .
2. To ease installation, remove all three drawers. To remove a drawer, simply slide the drawer out to its full
extent, lift the front and pull to remove.
3. Fit the tap as shown in the diagrams below. Fasten nut securely, ensuring the plastic fixing piece
B
is in the
correct position.
4. Fit the six adjustable feet supplied to the bottom of the cabinet and adjust to align with washing machine
height. Use the lock nut to secure the feet into position
C
. Tilt the Robinhood Workstation slightly to assist with
access. Check the top of the Robinhood Workstation with a spirit level to ensure that it is level and check that
the cabinet does not ‘rock’. Replace the drawers and check that they operate correctly and are flush fitting, if
not, re-adjust until they are correct. Remove drawers and continue with the installation.
5. Connect the hot and cold flexible hoses
D
to the mains.
6. Fasten the cabinet to the wall through the holes in the top rear flange. Fixing holes have been provided
throughout the rear flange
E
to ensure there is adequate position/positions in which to fasten the Robinhood
Workstation securely to the wall. Alternative fastening can be achieved through holes in the rear bottom panel
F
(through the floor or through the wall). (Australia only adapter supplied to convert the unit to 50mm).
E
F
D
Note: Rear flange has been removed for better visibility
B
C
A