5
Plumbing Connection
1.
Check inside the disposer to make sure that no foreign
objects are inside the grinding hopper.
2.
Place the metal bracket over the non-threaded end of the
waste outlet elbow.
3.
Attach the end of the waste pipe elbow into the slot in the
rubber gasket, ensuring that the circular ridge on the
rubber gasket is facing the main body of the unit, and the
flat side of the rubber gasket faces the waste pipe.
THIS
MUST BE DONE BEFORE INSERTING WASTE PIPE OR
MAY CAUSE THE UNIT TO LEAK.
4.
Use the screws to tighten the waste pipe to the disposer.
(NB: Do not over tighten). Tighten the two side screws
evenly using the hex key provided and ensure the metal
bracket lines up with the rubber gasket.
5.
Connect the pipe to the waste drain line. (NB: U-trap or P-
trap should be used, rather than a ball trap). Plumbers tape
is recommended to ensure a proper seal.
6.
If fitted to a double sink, the use of separate traps for the
disposer and the sink is recommended.
SAFETY NOTE: THE GRINDING TURNTABLES ARE EXPOSED UNTIL THE
WASTE PIPE IS ATTACHED.
DO NOT POWER UP THE UNIT UNTIL ALL PIPES ARE CONNECTED.
Air Switch Option (SEII500QA & SEII750QA models only)
1.
To install the push button air switch proceed as follows:
2.
Drill a 35 mm wide hole in the kitchen work top or corner of the
sink at the most convenient point for use.
3.
Unscrew the mounting ring of the air switch. Remove rubber washer.
Insert the air switch through the hole.
4.
Position rubber washer on the thread of the switch, then tighten
the locking ring until the washer is held firmly against underside
of the worktop or sink.
5.
Unscrew the black hexagon adapter on the underside of the
main waste disposal unit.
6.
Insert the end of clear tube through the adapter and then over
the male connector of the switch on the waste disposal and
tighten the two together.
7.
Push button to test waste disposal.
Your food waste disposal unit is now ready to use.
NOTE IF YOU CHOOSE NOT TO INSTALL YOUR AIR SWITCH: The Factory setting for Air Switch Models is the ON position. If your
unit fails to start after installation it may be set to the OFF position. TO set to ON, attached the Air Switch and the press once to
reset to ON. You can then detach the Air Switch from the unit if not required.
Testing
Once you have successfully connected your waste disposal, it is ready for use. However, it is still necessary to
ensure all your connections are secure.
A test run must be carried out to identify any immediate faulty connections or leaks.
1.
First, turn on the cold water to a medium-high flow, allowing the water to flow through the waste disposer.
2.
Check to see if there are leaks in the plumbing connections or waste disposer.
3.
Now, turn on the waste disposer and recheck all connections for leaks or loose joints.
4.
If at this point you see no leaks or loose joints, your waste disposer is safe for use.
5.
Turn off your waste disposer first and then the water supply.
