4
Dishwasher Connection (Optional)
If you plan on connecting your dishwasher drain pipe to your waste disposal, remove the plug in the
dishwasher drain connection opening with the help of a screwdriver and a rubber mallet. Remove the plastic
plug from the inside of the disposer by holding the disposer upside down and allowing the plastic plug to fall
out. Ensure all parts are removed.
The dishwasher drain outlet on your Robinhood waste disposal will accept a 22mm drain hose. Fasten the
connection tube in place with a hose clamp.
Mounting the Disposer
1.
The rubber splash baffle should be attached to the main body of the waste disposal and not the sink
flange. Using two hands, lift the main body upwards so that the splash baffle is sitting just under the
bottom mounting bracket.
2.
Lift the mounting ring slightly, and align the 3 lugs on the mounting ring with the lowest point on the
3 sloped sections of the mounting bracket. Turn the mounting ring anti clockwise and the main body
will begin to tighten against the mounting bracket. Once engaged the disposer will hang freely by
itself.
3.
Align the main unit so the waste outlet is able to be connected to the house plumbing. If the position
is wrong, re-do step 2, taking care to align the main unit appropriately before tightening the
mounting ring.
4.
The appliance must be installed so that the reset button located under the unit is readily accessible.
NOTE: Failure to use all supplied gaskets and seals or to mount the unit straight may mean that the unit does not fasten
tightly to the sink. Incorrect Installation may result in the unit leaking, and is not covered by warranty
