4
ELECTRICAL CONNECTION
Local Authority Requirements
Installation is only permitted by an authorized person, and carried out according to instructions
provided by the manufacturer. Incorrect installation might cause harm and damage which the
manufacturer accepts no responsibility.
Electrical Installation
Before carrying out the connection to the power supply, the voltage rating of the appliance (stamped on the
appliance identification plate) must be checked for correspondence to the available mains supply voltage, and the
mains electric wiring should be capable of handling the oven’s power rating (also indicated on the identification
plate).
NOTE
: For connections to the mains power supply, never use adapters, reductions or multiple power points as
these may overheat and catch fire.
After having installed the appliance, the switched outlet must always be in an accessible position.
The electrical safety of this appliance can only be guaranteed if the oven is correctly and efficiently earthed. The
manufacturer declines all responsibility for damage resulting from a system which has not been earthed.
WARNING
: It is essential to use specific soft wire or specific groupware bought from the manufacturer or
maintenance department to replace if the electrical soft wire has been broken.
Fitting a Power Supply Cable
Connecting appropriate power supply terminal board / connector block:
•
Using a screwdriver, prize open tabs of the Terminal board cover.
•
Remove the wire clamp screw.
•
Fasten the wires beneath the corresponding screw heads, using brass ‘bridge’ for single phase supply.
•
Fasten cable clamp screw and close the cover of the terminal board.
•
The ac power supply should be 220-240 V, 50/60 Hz.
－
－
The circuit breaker should be sized according to the load and should comply with current regulations (the earth
wire should not be interrupted by the circuit breaker).
The supply cable should be positioned so that it does not reach a temperature of more than 75
℃
with respect to
the room temperature, anywhere along its length.
