Installation -
continued
Built in cooktop cutout dimensions.
Contents of carton
1 x Cooktop,
4 fixing screws and clamps,
1 x sealing foam gasket
Installing the cooktop
Cut a hole in the benchtop that corresponds with the drawing shown above, it is important to have a gap of 25mm between
the underneath of the cooktop and any surface directly below it.
Installing the foam gasket
Before inserting the appliance into the opening in the kitchen benchtop, the supplied foam
gasket must be attached to the lower side of cooktop between the benchtop and cooktop.
Do not install the appliance without the foam gasket!
The gasket should be attached to the appliance in the following way:
•
Remove the protective film from the gasket.
•
Then, attach the gasket to the lower side of the cooktop, approximately 2-3mm from the edge.
•
The gasket must be attached along the entire length of the cooktop edge and should not overlap at the corners.
•
Do not use Silicone sealant to seal the cooktop to the surface as this will make removing for service calls difficult.
•
Place the clamp (B) over the holes that match the size of the screws. There are one set of
screw holes in each corner of the cooktop.
•
Slightly tighten a screw (C) through the clamp (B) so that the clamp is attached to
the cooktop,
but so that you can still adjust the position of it.
•
Carefully turn the cooktop back over and then gently lower it into the aperture hole that you
have cut out.
•
On the underneath of the cooktop, adjust the clamps into a position that is suitable for your
worktop. Then fully tighten the screws (C) to secure the cooktop into position.
3