Press (A) to start Timer #1. Press (B) to start Timer #2 and press (C) to start Timer #3. “RUN” will appear
and the brackets below the respective Lap Counter will flash.
Then, press (A), (B) and/or (C) to take Lap-Split readings. Again, you may release the frozen times by
pressing (E).
Press and Hold (A), (B) and/or (C) for two (2) seconds to stop the associated timer. “STOP” will appear
when all Chronographs are stopped. The time shown at “STOP” will be the time when you pushed the
button (not 2 seconds later).
To reset to all zeros, press and hold (B) for two (2) second while ALL timers are stopped.
ADVANCED FUNCTIONS
Fastest, Slowest and Average Lap Time
The Fastest (“MAX”), Slowest (“SLO”) and Average (“AVG”) lap for each timer can be displayed while
the chronograph is running or stopped, by pressing (F). The corresponding lap number will appear next to
the actual reading.
150 Memory Recall
Continue to press (F) to recall up to the previous 150 readings for each timer, while the Chrono is running
or stopped. The recall (“RCL”) indicator will appear when in use. You may press and hold (F) to scroll
through the previous readings. The memory recall data will disappear if no pushbutton is pressed within 15
seconds.
You may escape the recall procedure at any time by pressing (E). If the timer is running, simply press the
appropriate pushbutton to take a new time reading or stop the timer(s).
IMPORTANT: You cannot retrieve memory or other time data, if the display has been reset to all zeros.
ALWAYS retrieve memory and FAST/SLOW/AVG time data prior to resetting the Chronograph.
Time-out: The SC-888 has a “time-out” feature. If the event being timed is stopped for any reason, you
may stop and re-start the Chronograph without losing any prior readings. The lap counter(s) will register a
reading whenever running time is stopped.
To change modes during chronograph operation, press and hold (E) for two (2) seconds.
As a Single Chorine, the SC-888 will display Split time in the middle row and Lap or Split time in the
bottom row, with 1/100 second resolution to 24 hours.
PART V. SPEED TIMER OPERATION
The Speed Timer will compute and display speed in MPH/KPH as a function of time and distance, and
will
NOT operate, unless a distance has been entered.
To enter the Speed Mode from NORMAL TIME, press (E) twice. The “SPEEd” prompt will appear for
two (2) seconds. Upon entering, the Speed Mode should be in the reset position (all zeros). The Speed
Timer mode will not appear unless the Chronograph is in the reset (all zeros) position.
Distance Calculation
