CDT #1 Hours
Æ
CDT #1 minutes
Æ
CDT #1 Seconds
Æ
CDT #1 1/10 Seconds
Æ
CDT #2 Hours
Æ
CDT #2 minutes
Æ
CDT #2 Seconds
Æ
CDT #2 1/10 Seconds
Æ
CDT #3 Hours
Æ
CDT #3 minutes
Æ
CDT #3 Seconds
Æ
CDT #3 1/10 Seconds
Selecting CDT #1 , #2 and #3
To select the Countdown Timer(s) to be activated, press (C) while in the reset position. The bracket under
1, 2 and/or 3 will flash if that CDT will be activated. The sequence is as follows:
Press (C): CDT#1 only
Æ
CDT # 2 only
Æ
CDT #3 only
Æ
CDT #1 & CDT #2
Æ
CDT #2 & CDT #3
Æ
CDT #1, CDT #2 & CDT #3
Æ
back to CDT #1
NOTES:
(1) The SC-888 will not sequence through CDT #1, CDT #2 and/or CDT #3 while the timers are active or
stopped (but not Reset).
(2) Do not use the “LOOP” function if a single timer is selected. Should you want a single, preset time to
automatically repeat, select “RPT” during the set-up procedure.
Operating the Countdown Timer(s)
The Countdown Timer will not operate unless a preset time has been entered.
After configuring the Countdown Timer and entering the time(s), press (A) to start the timers. “RUN”
indicator will appear. Press (A) to stop and re-start the Countdown Timer(s), as needed.
A 20 second alarm will sound to signal the completion of the countdown, if the preset time is greater than
one minute. If the preset time is less than one minute, than the completion alarm is four (4) beeps. Press
any pushbutton to silence the completion alarm.
You may reset to the preset time(s) while the CDT is stopped by pressing (B).
Shop for quality Robic products on our website.
Learn more about sports equipment on our website.