Roberts Gorden CorayVac Classic SF Series, Operation & Service Manual

Page: 15 / 94

SECTION 5: M
AJOR
C
OMPONENTS
9 of 83
SECTION 5: MAJOR COMPONENTS
The fig u res in this section pro v ide a general o v er v ie w
of component placement in a CRVSF-Series system.
The location of some components s
u ch as s u pports
and co u plings is cr u cial for proper installation.
Assemble the heater components as sho w n on Page
15, Figure 12 .
Install appropriate s u spension hard w are, beam
clamps, chain or rod at predetermined locations.
Adj
u stments of chain or t u rnb u ckle length w ill pro v ide
u niform pitch. Thread pipe and fittings per ASTM.
See Page 4, Section 2 .
FIGURE 8 : Major Component Descriptions
Burner
Tube
Sched u le 40 steel pipe
(s u pplied by others.)
End Vent
Reflector
(Aluminum)
Alternate o v erlap as
sho w n
on Page 22,
Section 8.3.3 . Minim u m
o v erlap is 6" (16 cm).
Reflector
with Hole (Aluminum)
Alternate o v erlap as sho w n on
Page 22, Section 8.3.3
.
Minim u m o v erlap is 6" (16 cm).
Schedule 40
Adapter
Reflector Joint
Reflector End Cap
(Aluminum)
P u nch o u t center
section to
accommodate t
u be.
Tube and Reflector
Han
g er
S u spend system from
these hangers.
Reflector Support
Strap & Wire Form
Flex Gas Line
with shut-off cock
Cast-Iron Combustion
Chamber
Turnbuckle
Condensate
Valve Assembly
Schedule 40
Damper Nipple
ROBERTS-GORDON
®
3/ 8 " Sprin g Hook