Eminere Inground
5
3.1 Mounting the Eminere Inground
Warning!
If the Eminere Inground will be exposed to max. allowed static load, the subsoil under the installation sleeve has
to
withstand load of 35kN.
Example of installation of the Eminere Inground 2
1.
Prepare an adequate hole with a good drainage leaving at least 300 mm of gravel on the bottom of the
hole for inserting the mounting sleeve (1) into the prepared hole. There must not stay water in the
mounting sleeve.
2.
Remove the temporary cover (4) from the mounting sleeve (1) by unscrewing the six cap head allen bolts
(5).
3.
In sleeve that Emineres inground wil be installed side by side, the four holes (10) on the side of the
mounting sleeve serve for attaching next mounting sleeve by means of the four screws M5x10 (2) (with
washer and nuts). Two rubber grommets (3) insert to the holes (9) on the side of the mounting sleeve
which you will use for passing cables to next mounting sleeve (the rubber grommets insert to holes after
screwing both mounting sleeves together).
4.
The connection points (7) serve for grounding the mounting case and the junction box (8) for connection to
power/data.
5.
Connect the Eminere Inground (13) and all needed cables to the junction box (8).
Summary of Contents for ANOLIS Eminere Inground 2
Page 1: ...Version 1 1 ...
