Gas Hob
Gas Hob
9
10
Bottom functional location diagram
Use Instruction
1. Be sure the copper core, copper cover, copper base and pan stand in right
position. Check the switch first before turn on the valve of the gas. (Pic1)
2. IGNITION METHOD: Push the switch and turn to 90 degrees anti-clockwise for the
strongest flame, (Pic2) meanwhile the poop sound of pulse firing can be heard. The
full push should be taken for 3-5 seconds till the flame comes out. Otherwise, the
same operation above should be retaken. In addition, push the switch and turn to 90
degrees anti-clockwise again is the small flame. (Pic3)
Remark: The device shall not be operated for more than 15 s. If after 15 s the burner
has not lit, stop operating the device and open the compartment, door and/or wait at
least 1 min before attempting a further ignition of the burner.
Battery installation position
The position of the air inlet of the stove
360
370
380
390
400
710
700
690
680
670
660
400
390
380
370
360
7
1
0
7
0
0
6
9
0
6
8
0
6
7
0
6
6
0
7. The range of openings that this cooker can adapt to is:
Length 650mm-710mm, width 350mm-400mm;
For replacement installation, the installation method is as follows:
①
First, the installer measures the actual size of the user's home opening;
②
Wipe the chassis scale area with a clean cloth, and then paste the limit bars (four)
to the corresponding ones as shown in the figure below
Position, the outer edge is aligned with the corresponding tick line. After pasting,
press the limit bar hard to make it tightly fit (by company professionals
Installation).
③
Put the product with good limit strips into the opening, pay attention to the need
for leveling the cooker after placing, and ensure that each limit strip is embedded in
the opening.
It is recommended to use the product after 24 hours to ensure that the adhesive is
cured.
Cooker opening adjustment scale (length)
Cooker opening adjustment scale (width)
Take the measured opening size 700 × 400 as an example
The outer edge of the
limit bar is aligned with
the scale line 700
Limit bar outer
edge alignment
scale line 400
Note: Both sides are pasted
in the same way
