Roadtrek SS-Ideal, Owner'S Manual

Page: 22 / 72

DAILY LIVING
Doc No: 21906550 Rev: 00 Copyright © Roadtrek Motorhomes Inc. 2009 B-10
WASHROOM FACILITIES:
TOILET:
1. Privacy is achieved by closing both bathroom
doors.
2. The washroom is equipped with an exhaust vent,
(see Picture B-P26).
PERMANENT BATHROOM SHOWER:
To set up the bathroom shower:
1. Remove the floor drain plug from the bathroom
floor, (see Picture P-B30).
2. Privacy is achieved by closing both doors and
securing them using the inside shower door latch,
(see Picture B-P25).
3. Install the shower hose on the bathroom faucet.
Place the shower head in the, (in use) holder,
(see Picture B-P31).
4. Draw the shower curtain until you have covered
the bathroom doors.
5. Using the Velcro connectors, secure the edges of
the curtain to the shower interior walls.
6. When adjusting the water temperature, be sure to
allow enough time for the temperature adjusted
water to exit the shower head before making
further adjustments.
7. The bathroom exhaust vent may be used to
remove steam and moisture.
Note: The shower hose is self-draining. When the water
is turned off, the hose drains out the bottom.
To put away the stand-up shower:
1. Rinse and dry the shower curtain thoroughly,
(this function is most easily performed before
leaving the shower area after use).
2. Allow the curtain to air dry completely, (this
function can be expedited using the power roof
vent or the bathroom vent).
3. Replace the floor drain plug when you are finished.
To prevent grey water tank contents from spilling onto the floor
while driving, keep the drain plug secured when not in use.
Picture B-P31: Shower head location while in use.
Picture B-P32: Storage compartment in bathroom
vanity, (used for storage of extra toilet tissue and
other supplies).
Picture B-P30: Location of bathroom shower drain.